Novak M2 Dig 3S Dual Brushed Motor ESC

Novak M2 Dig 3S Dual Brush ESC
Picture the functionality and utility of two Novak Goat Crawler Speed Controls in brushed mode and Novak’s Dig Unit; now, envision it in one highly programmable, inexpensive speed control and you get the revolutionary M2 Dig 3S Dual Brush ESC. This patent-pending, new controller combines 6 adjustable parameters with its revolutionary performance including a separated drag brake and dig function.
With only the addition of two brushed crawler motors, the M2 Dig controls both motors and performs dig maneuvers. In addition to the standard Dig Mode, the M2 features a Proportional Dig Mode which allows you to dial-in partial Dig Power on the fly for even finer control and precise maneuverability through tricky terrain. It also features an exceptional control on steep inclines and descents. Plus, the built-in electronic Dig Power is independently adjustable from the Hill/Drag Braking. This truly unique speed control supports both 2S and 3S LiPo!
Because of its unique features, the M2 Dig 3S is perfect for the new Axial XR10! The M2 Dig 3S ESC / Dual Terra Claw Brush Motor Combo (NE1845) is matchless when used in Motor-On-Axle vehicles, exceeding the performance of traditional two-system setups. The M2 ESC is also compatible with other dual-MOA vehicles, such as EnRoute’s Berg, Integy’s Super and Unlimited Class of crawlers, and Clod Buster-based vehicles.

Novak M2 Dig Features
Fully programmable, user-friendly interface with five adjustable parameters: Drag Brake (10 settings), Dead Band (5 settings), Minimum Drive (10 settings), Drive Frequency (10 settings) and Battery Type Selection (3 settings – Li-Po, Li-Fe and NiMH)
Three throttle profiles: Dig Mode, Proportional Dig Mode and Single Outpu Mode
Independently powers the front or rear motors in a dual-motor crawler vehicle
Operates on both 2S and 3S applications
Instant reverse via Novak\'s Zero Reverse Delay providing immediate power delivery in both forward and reverse.
Compatible with optional NovaLink (NE5440) for expanded programming and ability to download firmware updates to the ESC
Internal high-voltage 5-Amp Linear BEC
Universal JST Input Plug for Ch.2 and Ch. 3, which fits all popular brand receivers
Water-resistant case with gasket seal
Thermal Overload Protection
Features a set of power output pins for running cooling fans, auxilary lights, scale winchces, etc.

The compact M2 Dig ESC is easy to install and operate. There are three fully programmable throttle profiles: Dig Mode, Proportional Dig Mode and Single Output Mode.
Dig Mode is the default setting, and uses Dig Power (independent of Drag Brake) to lock one motor at a time.This mode requires a proportional switch or a simple three-position switch to operate.
Proportional Dig Mode. This completely original mode uses a transmitter\'s third channel that is proportional (button or dial), allowing drivers to vary the amount of Dig Power being applied to the motor. This innovative feature provides seemingly endless fine tuning of the Dig for the ultimate vehicle control.
Single Output Mode is for applications with single motors or operation without a 3-channel transmitter. In this mode all four motor power wires can be soldered to one brush motor for higher performance, or connect two motors and control them both at the same time.

In addition to crawling applications, the M2 Dig 3S ESC is ideal for applications that require two motors, such as robots, boats, tanks and submarines.

Novak M2 Dig Specifications:
Input Voltage: 2-3 Li-Po/Li-Fe cells or 4-9 NiMH cells (1.2V/cell)
On-Resistance (dual motor): 0.0016 ohm. at 25 degrees C trans. temp.
On-Resistance (single motor): 0.0008 ohm. at 25 degrees C trans. temp.
ESC Footprint: 1.16” x 1.47” (29.5 x 37.3 mm)
ESC Weight (w/o wires): 1.30 oz. (36.9g)
Motor Limit: 27-turn (Single), 33-turn (Dual) 540-sized dual brushed motors
BEC: 6.0 volts DC / 5.0 amps
Status LEDs: 4 on-board; 2 external
Voltage Cut-Off: 6.25V (2S Li-Po), 9.38V (3S Li-Po) (Automatic)
Power Wires: 14G Super-Flex Copper-Strand Silicone Wire