Eiger Pro 2S/3S Crawling Brushed

This is the Novak Eiger Pro 2S/3S Electronic Speed Control
for Brushless or Brushed Crawler Motors.

FEATURES

#5463 3A BEC module allows 3S LiPo battery usage

Additional motor wire to connect a 10.5 turn or higher brushless

motor for use with 2S LiPo packs

May be used for brushless class racing, crawling (when used with a

Novak crawling brushless motor), or bashing around

Brushless mode includes on-board programming to customize and fine-

tune the feel of the ESC

Compatible with 2-3S LiPo cells and 4-9 cell NiMH batteries (2S only

with brushless motor)

Three throttle modes;

Rock Crawl Mode with adjustable drag brake power

Standard/Basher Mode for normal FWD/BRK

Robotic or Servo Mode for FWD/REV operation only

Four adjustable parameters;

Brake Power/Throttle Mode (5 settings)

Dead Band (5 settings)

Drive Frequency (5 settings)

Voltage Cut-Off

Non-crawling basher mode can be used in any 1/10, 1/12, 1/16, or

1/18 scale application with a 20 turn or higher brushed motor

One-Touch programming interface with four multi-colored status LEDs

6V output for cooling fan or other options such as running lights

Temperature monitoring allows user to check ESC operating temperature

at any time

Thermal overload protection to prevent overheating

Water-resistant case with silicone gasket seal

One touch setup

RoHS compliant

INCLUDES

Novak Eiger Pro ESC with Gold Plated Bullet Motor Plugs, Mounting
Tape, Power Cap, Wires, Heat Sink, 3A BEC Module, Instruction
Manual

REQUIREMENTS

Installing in vehicle and connecting to battery, receiver and motor
Battery connector to match selected battery

SPECIFICATIONS

Motor Limit: 2S Brushed, 20T or higher, any 380 size
3S Brushed, 20T, any 380 size
2S Brushless, 10.5T or higher, any 380 size
Input Cells: 2-3S LiPo or 4-9 NiMH
Size: 1.15 x 0.95 x 0.75" (29.0 x 24.3 x 20mm)
Weight: 0.75oz. (21.31g) without wires
On-Resistance: 0.00036 ohms
BEC: 6V DC/3A
Wire Size: 14G Super-Flex Copper-Strand Silicone Wire