Eiger 2S/3S Crawling Brushed/Bru

This is the Novak Eiger 2S/3S Electronic Speed Control
for Crawler Vehicles with Brushless or Brushed Motors.

FEATURES

Additional motor wire to connect a 10.5 turn or higher brushless

motor for use with 2S LiPo packs

May be used for brushless class racing, crawling (when used with a

Novak crawling brushless motor), or bashing around

Brushless mode includes on-board programming to customize and fine-

tune the feel of the ESC

Compatible with 2-3S LiPo cells and 4-9 cell NiMH batteries (2S only

with brushless motor)

Heavy duty 2-amp BEC

Three throttle modes;

Rock Crawl Mode with adjustable drag brake power

Standard/Basher Mode for normal FWD/BRK

Robotic or Servo Mode for FWD/REV operation only

Four adjustable parameters;

Brake Power/Throttle Mode (5 settings)

Dead Band (5 settings)

Drive Frequency (5 settings)

Voltage Cut-Off

Non-crawling basher mode can be used in any 1/10, 1/12, 1/16, or

1/18 scale application with a 20 turn or higher brushed motor

One-Touch programming interface with four multi-colored status LEDs

6V output for cooling fan or other options such as running lights

Temperature monitoring allows user to check ESC operating temperature

at any time

Thermal overload protection to prevent overheating

Water-resistant case with silicone gasket seal

One touch setup

RoHS compliant

INCLUDES

Novak Eiger ESC with Gold Plated Bullet Motor Plugs, Mounting Tape,
Power Cap, Wires, Heat Sink and Instruction Manual

REQUIREMENTS

Installing in vehicle and connecting to battery, receiver and motor

SPECIFICATIONS

Input Cells: 2-3S LiPo or 4-9 NiMH
Size: 1.15 x 0.95 x 0.75" (29.0 x 24.3 x 20mm)
Weight: 0.75oz. (21.31g) without wires
On-Resistance: 0.0013 ohms
Motor Limit: 2S Brushed, 20T or higher, any 380 size
3S Brushed, 35T, any 380 size
2S Brushless, 10.5T or higher, any 380 size
BEC: 6V DC/2A
Wire Size: 14G Super-Flex Copper-Strand Silicone Wire